Filter
Top Products
vi
Notices
Notices for Customers in Canada
CAUTION : This class B digital apparatus complies with Canadian ICES-003.
ATTENTION : Cet appareil numerique de la classe B est conforme a la norme
NMB-003 du Canada.
❏ IC RSS-GEN Exposure of Humans to RF Fields
This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation of this
device.
This device has been designed to operate with an antenna having a maximum
gain of 2.1 dBi. Industry Canada regulations strictly prohibit antennas with
higher gain. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power
(EIRP) is not more than that required for successful communication.
Co-location
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
FCC/IC RF Exposure Statement
The available scientific evidence does not show that any health problems are
associated with using low power wireless devices. There is no proof, however,
that these low power wireless devices are absolutely safe. Low power Wireless
devices emit low levels of radio frequency energy (RF) in the microwave range
while being used. Whereas high levels of RF can produce health effects (by
heating tissue), exposure to low-level RF that does not produce heating effects
causes no known adverse health effects. Many studies of low-level RF
exposures have not found any biological effects. Some studies have suggested
that some biological effects might occur, but such findings have not been
confirmed by additional research. This Wireless Transmitter (WT-4A), which is
equipped with an SX-10WAG (FCC ID: N6C-SX10WAG / IC: 4908B-SX10WAG)
Wireless LAN Module, has been tested and found to comply with FCC radiation
exposure limits set forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of
the IC radio frequency (RF) Exposure rules. Please refer to the SAR test report
that was uploaded to FCC website.
This WT-4A has been tested and meets the FCC RF exposure guidelines when
used with the Nikon Corporation accessories supplied or designated for this
product. Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.