Filter
Top Products
44
EXTERNAL DEVICE
PAN/TILT SETUP - SPEED
SETUP
1. PAN SPEED - Set the PANing speed (0
low ~ 7 high).
2. TILT SPEED - Set the TILTing speed (0
low ~ 7 high).
3. ZOOM SPEED - Set the speed of ZOOM
IN/OUT (0 low ~ 7 high).
SPOT SETUP
1. SWITCH INTERVAL - Sets the sequence
switching time (01 ~ 99 sec.).
2. ALARM POP UP - When an Alarm is
detected, the corresponding channel
(connected to the Alarm sensor block) pops
up onscreen.
3. MOTION POP UP - Sets the MOTION
detection pop-up to ON/OFF.
4. EVENT POP UP DURATION - If ALARM
or MOTION events occur concurrently on
several channels, then Channel 1 has first
priority for onscreen POP UP.
• For example, if an events occurs on
Channel 1, Channel 2 and Channel 4 at
the same time, Channel 1 pops up. If
motion stops on channel 1, then channel
2 pops up for the set duration. If motion
occurs on Channel 1 again (within the
duration), Channel 2 continues to
display. If motion on Channel 1 keeps
on going even after the duration,
Channel 1 pops up again.
RS232C SETUP
Users can connect the System to a PC
through the RS232 port. Other system
control devices can also be connected
through the RS232 port. The ASCII-Code
information is in Serial port setup (Users
cannot change value in this setting).
1. BAUDRATE - The transmission baudrate
is 19200bps.
2. LENGTH - The transmission length is 8
bits.
3. STOP BIT - The stop bit is 1.
4. PARITY - The parity is none.