Filter
Top Products
9
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
WARNING
Failure to position the parts in
accordance with these diagrams
or failure to use only parts
specifically approved with this
appliance may result in property
damage or personal injury.
AVERTISSEMENT
Risque de dommages ou de
blessures si les pièces ne sont
pas installées conformément à
ces schémas et ou si des pièces
autres que celles spécifiquement
approuvées avec cet appareil
sont utilisées.
MINIMUM CLEARANCES* Inches (millimeters)
Back and Sides 1/2 in. (13)
0 (0) from Spacers Or Dimples **
Top Spacers 0 (0)
Floor 0 (0)
From Bottom of Unit To Ceiling 64 (1626)
Vent 3 (76)
Top* / 1 (25.4) Sides & Bottom
SERVICE CLEARANCES Feet (meters)
Front, Back, Sides 3 feet (0.9 meters)
Table 5
Top Bustle
Top Radiant Panel
Bottom Bustle
Control Compartment Access Panel
Figure 10 Unit Parts Identification
17"
14"
Min. Distance To
Unprotected Side Wall
8-1/4"
45°
Combustible Materials
Allowed In Shaded
Area Safe Zone
12"
5"
Min. Distance
To Protected
Side Wall
Top View Of
Fireplace
Side
Wall
Side
Wall
DETAILED INSTALLATION STEPS
The appliance is shipped with all gas controls
and components installed and pre-wired.
1 - Remove the shipping carton.
2 - Remove the top radiant panel (refer to
Figure 11 ).
3 - Lift the pressure relief plates and remove
the cardboard from underneath each of
them.
4 - Open the control compartment access
panel, by actuating the spring-loaded magnetic
catches securing the panel, gently depressing
the outer top corners of the panel until the
catches "pop" the panel free and allowing it to
swing out and down to open.
5 - Remove the bottom control compartment
access panel by compressing the spring-
loaded hinge pin on the left side until it
disengages from the left cabinet panel hole.
Pull the panel away from the fireplace. See
Figure 56 on page 30.
6 - Remove the modesty panel by pulling the
bottom right corner of the modesty panel out
slightly to disengage the snap-fit feature; lift the
modesty panel by the tab on the panel's right
end, pull the right end of the panel away from
the cabinet and then pull the panel diagonally
out of the left side cabinet panel slots. (In
the above procedure, reverse the words "left"
and "right" for EDVCR models). Remove the
modesty panel carefully, so that none of the
wires become loose or disconnected.
7 - Open the two latches (located under the
firebox floor) securing the glass enclosure
panel. Remove the panel by tilting it outward
at the bottom and lifting it up. Set the door
aside protecting it from inadvertent damage.
See Figure 63 on page 34.
Figure 9