Filter
Top Products
2
The assembled vented gas stove heater is packaged with:
one - log set located in firebox
one - ember strip located beneath stove
body (on pallet)
one - bag of glowing embers located in
the firebox
one - envelope containing the literature
package which consists of the
homeowner's manual, installation
instructions and warranty; located
on the top of the firebox
one - cast iron top
one - trivet
one - natural gas to propane conversion kit
one - ash lip
one - lower access door
four - leg levelers
TABLE OF CONTENTS
Packaging .......................................................................... Page 2
Introduction ....................................................................... Page 2
Safety and Warning Information ........................................ Page 3
General Information ...........................................................Page 5
High Altitude ...................................................................... Page 5
Location .......................................................................................Page 6
New York City, New York (MEA) .................................................Page 6
Commonwealth Of Massachusetts Requirements .....................Page 6
Specifications ..................................................................... Page 7
Appliance and Vent Clearances .......................................... Page 8
Manufactured Home Requirements ............................................Page 9
Questions to Ask Local building Official ............................. Page 9
Vent Termination Clearances ............................................. Page 9
Typical Installation Sequence ............................................ Page 11
Detailed Installation Steps ..................................................Page 11
Step 1 Preparation ............................................................... Page 11
Step 2 Remove Packaging ..........................................................Page 11
Step 3 Remove Stove From Pallet .............................................Page 11
Step 4 Remove Front Glass ........................................................Page 12
Step 5 Remove Firebox Contents ................................................Page 13
Step 6 Remove Cardboard Packaging. .......................................Page 13
Step 7 Install LP Conversion / Options .......................................Page 13
Wiring Diagrams ..........................................................................Page 13
Step 8 Install Lower Access Door ...............................................Page 14
Step 9 Install Venting ...................................................................Page 14
Step 10 Connect Gas Line ...........................................................Page 18
Step 11 Install Log Set ................................................................Page 18
Step 12 Reinstall Front Glass ......................................................Page 20
Step 13 Perform Leak Test ..........................................................Page 20
Step 14 Check Appliance Operation ............................................Page 21
Step 15 Adjust Burner ................................................................Page 21
Step 16 Install Top, Trivet & Ash Lip ...........................................Page 22
Step 17. Attaching Safety in Operation Warnings ......................Page 23
Rating Plates ................................................................................Page 24
This manual is part of a set of two supporting this product. Refer to
manual 775,148M for Care and Operation.
This installation manual will help you obtain a safe, efficient, depend-
able installation for your appliance and vent system.
Please read and understand these instructions before beginning
your installation.
These Millivolt appliances are listed by OMNI-Test Laboratories Inc.
for installation in bedrooms and manufactured (mobile) homes.
PACKAGING LIST
These vented gas heaters are sealed combustion, air circulating gas
stoves designed for residential applications. These appliances must
be installed with "Security Secure Vent
TM
" or "Simpson Dura Vent"
brand vent systems routed to the outside atmosphere (other brands
may not be used).
Millivolt appliances are designed to operate on natural or propane
gas. A millivolt gas control valve with piezo ignition system provides
safe, efficient operation. External electrical power is required to operate
the optional blower if installed on these units.
These appliances comply with National Safety Standards and are tested
and listed by OMNI-Test Laboratories Inc.; Beaverton, Oregon (Report
No. 116-S-08-05) to ANSI Z21.88 (in Canada, CSA-2.33), and CAN/
CGA-2.17-M91 in both USA and Canada, as vented gas heaters.
Installation must conform to local codes. In the absence of local codes,
installation must comply with the current National Fuel Gas Code, ANSI
Z223.1. (In Canada, the current CAN/CSA-B149.1 installation code.)
Electrical wiring must comply with the National Electrical Code ANSI/
NFPA 70 - latest edition. In Canada, the current CSA C22-1 Canadian
Electrical Code - latest edition.
DO NOT ATTEMPT TO ALTER OR MODIFY THE CONSTRUCTION OF THE APPLI
-
ANCE OR ITS COMPONENTS. ANY MODIFICATION OR ALTERATION MAY
VOID THE WARRANTY, CERTIFICATION AND LISTINGS OF THIS UNIT.
INTRODUCTION