Filter
Top Products
12
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Note: Install Leg Leveling Bolts if Necessary: The four leg leveling bolts
(included in literature package), are provided for leveling the stove if
necessary. To install, thread the bolts into the existing holes in the bottom
of each leg. Turn the leveling bolts to adjust for correct height.
Step 4: REMOVE FRONT GLASS ENCLOSURE PANEL
Remove the front glass enclosure from stove as follows:
A. Locate and open the 2 latches below the stove body (See Figure
6).
WARNING
Never operate appliance without the front glass enclosure
panel in place and secure.
Open both Latches as shown.
Figure 6
B. Reach under the bottom front of the front glass enclosure and pull
it forward as shown in Figure 7.
Figure 7
Only doors certified with the appliance shall be used.
Seules des portes certifiées pour cet appareil doivent être
utilisées.
CAUTION: DO NOT abuse glass door by striking or slamming
shut.
Do not remove glass door while the appliance is hot.
WARNING
• Do not attempt to substitute the materials used
on these doors, or replace cracked or broken
glass.
• Handle this glass with extreme care! Glass is
susceptible to damage – Do not scratch or handle
roughly while reinstalling the glass door frame.
• The glass door(s) of this appliance must only be
replaced as a complete unit as provided by the
manufacturer. Do not attempt to replace broken,
cracked or chipped glass separately.
• Do not attempt to touch the front enclosure glass
with your hands while the appliance is in use.
WARNING
Do not operate appliance with the glass front
removed, cracked or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le panneau frontal en
verre n'est pas en place, est craqué ou brisé.
C. Lift glass assembly up and out and carefully set aside in a safe
place (see Figure 8).
Figure 8