Filter
Top Products
Mark for placement of buttonhole
(_ Starting point
Slider
(_) There shoud be no gap.,
(_ Spring holder
(_) Difference
Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the
needle at the starting point.
Then lower the automatic buttonhole foot°
Make sure there is no gap _ between the slider
(_) and the spring holder (:Z)..
If there is a gap (_, the length of the rows wilt be
different, as shown in ®..
Sew slowly and stop the machine at the starting
point when a buttonhole is completed_
Remove the fabric and place a pin just before the
bartack at each end to prevent cutting bartacks.
Cut the opening with the buttonhole opener.
After a buttonhole is sewn, move the selector to the
next stitch by turning the stitch selector in direction
of (_ or (_, then return the stitch back to " _ "to
reset for sewing the next buttonhhole.
f
f
®
When finished, push the buttonhole lever up as far
as it will go.
f
76