Filter
Top Products
Prepare the Bobbin
o Put Thread on the Spool
f
Ordinary spool
Large _ _ .
_pooI __ spoo_
holder //////_._ pi_
Small spool
Small "_,_> .,.i---_ Spool
NOTE: Your spool pm tilts upward for
ease m pulling thread on the
spool.
You have two spool holders:
large (under the top cover)
(in your accessory box).
1.
and small
Choose the appropriate spool holder.
2. Place your thread on the spool pin and
then fit the spoot holder down over it,
so that the thread winds toward the
back of the machine, as shown.
3. Press the spool holder against the spool.
4. Lower the spool into the well.
• Additional Spool Pin
......J
NOTE: For winding the bobbin white your machine Is threaded, you have an extra
spool pin in your accessory box. _t fits into the square ho}e on top of
your machine near the bobbin winder.
To Use This Extra Spool Pin:
1. Fit the square end of the spool pin into the square hote, as shown.
2. Fit the spool pin felt on the base of the spoof pin.
3. Put your spool of thread on top of the felt, with the thread winding m the
direct{on shown. See directions for winding the bobbin, p. 19 _ 20.
18