Filter
Top Products
37
[6] After sewing the buttonhole stitch, raise the button-
holelever until it stops.
12 Buttonhole lever
[7] Place a pin on the rear side of the bartack position
so that you donÕt need to worry about cutting the
end of the buttonhole stitch.
Cut the opening with the seam ripper in your acces-
sorybox.
13 Pin
14 Seam ripper
15 Punch (use for keyhole buttonhole 10)
Adjusting Stitch Width and Density in Buttonholes
[To change the stitch width]
The stitch width key controls the stitch width.
The pre-set buttonhole widths are: square buttonhole
5.0, rounded buttonhole 4.0, keyhole buttonhole 7.0.
Press “+” or “-” to adjust the stitch width of the entire
buttonhole, ranging between 2.5 to 7.0 depending on the
selected buttonhole.
1 Narrower width by pressing “-”
2 Wider width by pressing “+”
[To Change Stitch Density]
The stitch length key controls the stitch density.
The pre-set density varies from 0.4 to 0.7 according to
the buttonhole selected.
Press “+” or “-” to adjust the stitch density of the entire
buttonhole between 0.2 to 1.0 depending on the selected
buttonhole.
Press “+” or “-” to adjust the stitch density between 0.5
to 1.0 for the buttonhole density for .
3 Denser stitch by pressing “-”.
4 Coarser stitch by pressing “+”.
[6]
[7]
12 3 4
12
13
14
15