Filter
Top Products
Lubrication
The motor is equipped with bearings which contain sufficient lubrication for the
liie of the motor. The addition of lubricant could cause damage.
Do not add
lubricant to motor bearings.
The agitator is equipped with two ball bearings that should be lubricated
periodically by a Hoover Factory Service Center or an Authorized Hoover
Warranty Service Dealer (Depot).
If you have a problem
This appliance was inspected thoroughly and was in good operating condition
when it was shipped from the factory.
If a minor problem occurs, it usually can
be solved quite easily when the cause is found. Therefore, this check list is
provided for your convenience.
Problem
Possible cause
Possible solution
Cleaner
won’t
run
I.
Not
ftrmly
plugged in.
2.
No voltage In wall plug.
3.
lbWwlfl~seArlpped
.
I.
Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
Cleaner
won’t
pick up
I.
Broken or worn belt.
2. Agitator brush roll
worn.
3. Bag full.
4. Incorrect carpet height
setting.
5. Hose end notsecure In
tool rack
I.
Replace belt.
2. Replace brush roll.
3. Change paper bag.
4. Move
nonle
control
knob to type of carpet
being cleaned.
5. Push hose end firmly
into
%up”
In tool rack=
Cleaning
I.
Hose clogged
I.
Remove hose and tools;
tools won’t
remove obstructlon.
pick up
2. Incorrect
setting.
2. Move knob to “Cleaning
Tools”.
Cleaner
hard
to push
I.
Incorrect carpet height
setting.
I.
Move nozzle control
knob to a higher setting.
26