Filter
Top Products
3. Pull out shaft, being careful to
leave washer on shaft.
4. Reinsert shaft to push out
opposite agitator end.
5. Repeat in other direction to push
out second agitator end.
6. Discard old agitator brush roll.
7. Place agitator ends into new brush
roll, matching projections in roll with
openings in ends. Push ends firmly
into place. (If bearing comes out of
agitator end during disassembly,
place washer and bearing back into
agitator end, with white side of
bearing out, before inserting shaft.)
8. Insert shaft (with washer) into
agitator. Replace end plate and
tighten.
No&x
Be sure shaft is inserted so
that end plate with flat-sided
projection is secured onto belt end
of agitator roll.
Use this illustration for reassembly,
if necessary. Washer must be
placed between agitator ends and
bearing.
9. Replace agitator and belt as
shown in steps 4-8 of “How to
replace belt.’
25