Filter
Top Products
CHAPTER 3
SHOWGUN® Menu System
22 SHOWGUN
®
User Manual
Lamp Life Limit
Use this menu option to display the warning message Lamp Life Error when the current lamp
hours reach the rated lamp life. When the
LAMP LIFE LIMIT parameter is enabled, the fixture
tracks the number of hours the lamp is on. At 650 hours, it displays an error message. At 710
hrs., the lamp shuts off, and the fixture will not strike until the lamp is replaced and the lamp
hours are reset to 0. See
Replacing the Lamp on page 38 and Lamp HR/Strike Reset on page 27.
To enable the LAMP LIFE LIMIT parameter:
1. Press the Menu button to unlock the menu system or to move back up the system to the top
level menus.
2. Using the left and right arrows on the Center button, scroll through the top level to SET
PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Center button, scroll to LAMP LIFE LIMIT.
4. Using the up and down arrows on the Center button, choose the ENABLE option and press
Enter to select.
Data Loss Timeout
Use this menu option to determine how the fixture will react in the event of DMX data loss. Set
the shutter to stay open until shutdown or to close one second after data loss.
To set the DATA LOSS TIMEOUT:
1. Press the Menu button to unlock the menu system or to move back up the system to the top
level menus.
2. Using the left and right arrows on the Center button, scroll through the top level to SET
PARAMETERS MENU and press the Enter button to select.
3. Using the left and right arrows on the Center button, scroll to DATA LOSS TIMEOUT.
4. Using the up and down arrows on the Center button, choose LONG to keep the shutter open
until shutdown, or
SHORT to close the shutter 1 second after data loss and press the Enter
button to select.