6
Water Pressure:
Water Quality:
with sand or sediment in the water. (This problem occasionally
Note: Well and/or
pump problems affecting the operation of the softener are repairs
that are not covered under warranty. To prevent these unneces-
sary, and expensive repairs that are not covered under warranty,
we recommend the installation of an in-line lter system ahead
of the softener.
Electrical: A continuous 110 volt, 60 cycle current supply is
Make certain the current supply is uninterrupted and
cannot be turned off with another switch. All electrical connec-
tions must be connected per local codes. Surge protection is
recommended with all electric controls.
Existing Plumbing:
conditioner to correct the problem.
Drain Line: The conditioner should be located close to a drain.
Bypass Valves:
valve.
Softening:
Caution:-
PRE-INSTALLATION CHECK LIST
(All electrical & plumbing should be done in accordance to all local codes)
BYPASS VALVE OPERATION