Hellenbrand H-150 Series Water System User Manual


  Open as PDF
of 40
 
11
Manual Regeneration


water usage.
To initiate a manual regeneration at the preset delayed regeneration time, press and
release “REGEN”. The words “REGEN TODAY” will ash in left corner of display as it
scrolls through displays to indicate that the system will regenerate at the preset delayed
regeneration time. If you pressed the “REGEN” button in error, pressing the button
again will cancel the request.
To initiate a manual regeneration immediately,-

This will reset the meter.
Note: If the salt tank does not contain salt, ll with salt and wait at least two hours before regenerating. If two regenerations
are desired within 24 hour period, press /release REGEN button. REGEN TODAY will ash on screen. Press and hold REGEN
button until valve initiates regeneration.
Figure 11
CYCLE TIME ADJUSTMENTS



Cycle Options Units Lower/Upper Limit Factory Setting
   
   
  
Regenerant Draw DN Minutes 1 to 180 60
  
  
Step 1S
Step 2S
SOFTENING
Step 3S
FILL
30.0
STEP 1S –
not appear in 5 seconds the lock on the valve is activated.
STEP 2S – Select between softening or ltering.-
or button. Factory setting is
Softening.
STEP 3S – Select the time for the rst cycle
or button. Factory setting is Medium
Salting, 
step.
"REGEN TODAY"
320
CAPACITY REMAINING
GAL
SOFTENER SETUP
Regeneration Step
(shows time remaining in regen step
is 8 minutes, 22 seconds)
BACKWASH
8:22
= Up Arrow = Down Arrow
SET
SET
TYPE
LBS
Regeneration Mode


is regenerating, untreated water will be supplied.



when the regeneration has been completed.
 previous next