Filter
Top Products
32
H150 SPECIFICATIONS
H150 H150 H150 H150 H150 H150
Model # 60 90 120 150 150-21 180
Factory Regeneration Settings
Backwash Minutes 10 10 10 10 10 10
Gallons 42 42 53 75 90 75
Brine/Rinse Minutes 60 60 60 60 60 60
Gallons 45 75.6 84 114 150 114
Backwash Minutes 6 6 6 6 6 6
Gallons 25 25 32 45 54 45
Fast Rinse Minutes 6 6 6 6 6 6
Gallons 25 25 32 45 54 45
Fill Minutes 13:14 19:56 26:38 33:20 33:20 40:02
Gallons 6.5 9.8 13.2 16.6 16.6 20
Total Regeneration Gallons* 144 178 214 296 365 299
Refill LBS / Minutes Lbs. Min. Lbs. Min. Lbs. Min. Lbs. Min. Lbs. Min. Lbs. Min.
Low Salt 12 8 18 12 24 16 30 20 30 20 36 24
Medium Salt 20 14 30 20 40 27 50 34 50 34 60 40
High Salt 30 20 45 30 60 40 75 50 75 50 90 60
Capacity Grains Grains Grains Grains Grains Grains
Low Salt 38,000 57,000 76,000 95,000 95,000 114,000
Medium Salt 56,000 84,000 112,000 140,000 140,000 168,000
High Salt 64,000 96,000 128,000 160,000 160,000 192,000
Service Flow Rates * GPM GPM GPM GPM GPM GPM
Continuous @ 15 psi 33 33 36 40 46 37
Peak @ 25 psi 42 44 50 54 63 52
Flint Under bed (lbs.) 30 35 40 50 85 50
High Capacity Resin (cu.ft.) 2 3 4 5 5 6
Resin Tank Size 13x54 14x65 16x65 18x65 21x62 18x65
Recommended Brine Tank 18x40 18x40 24x41 24x50 24x50 24x50
DLFC (gpm) 4.2 4.2 5.3 7.5 9 7.5
BLFC (gpm) 0.5 0.5 0.5 0.5 0.5 0.5
Injector Size C-RED D-WHITE E-BLUE
F-YELLOW G-GREEN F-YELLOW
Injector Draw Rate (gpm) @ 50 psi 0.55 0.85 1 1.3 1.8 1.3
Injector Slow Rinse (gpm) @ 50 psi 0.75 1.26 1.4 1.9 2.5 1.9
*Service flow rates are with hub and lateral type of distributor and may be lower with a stack type of distributor.
H150 Specifications
* Calculations are based on factory medium salt setting @ 50 psi