Filter
Top Products
33
H150 SPECIFICATIONS
H150 H150 H150 H150 H150
Model # 180-21 210 240 270 300
Factory Regeneration Settings
Backwash Minutes 10 10 10 10 10
Gallons 90 90 120 120 120
Brine/Rinse Minutes 60 60 60 60 60
Gallons 150 150 204 204 204
Backwash Minutes 6 6 6 6 6
Gallons 54 54 72 72 72
Fast Rinse Minutes 6 6 6 6 6
Gallons 54 54 72 72 72
Fill Minutes 40:02 46:44 53:26 60:08 66:50
Gallons 20 23.2 26.6 30 33.3
Total Regeneration Gallons* 368 371 495 498 501
Refill LBS / Minutes Lbs. Min. Lbs. Min. Lbs. Min. Lbs. Min. Lbs. Min.
Low Salt 36 24 42 28 48 32 54 36 60 10
Medium Salt 60 40 70 47 80 53 90 60 100 67
High Salt 90 60 105 70 120 80 135 90 150 100
Capacity Grains Grains Grains Grains Grains
Low Salt 114,000 133,000 152,000 171,000 190,000
Medium Salt 168,000 196,000 224,000 252,000 280,000
High Salt 192,000 224,000 256,000 288,000 320,000
Service Flow Rates * GPM GPM GPM GPM GPM
Continuous @ 15 psi 45 44 46 45 45
Peak @ 25 psi 61 60 62 61 60
Flint Under bed (lbs.) 85 85 125 125 125
High Capacity Resin (cu.ft.) 6 7 8 9 10
Resin Tank Size 21x62 21x62 24x72 24x72 24x72
Recommended Brine Tank 24x50 24x50 24x50 30x50 30x50
DLFC (gpm) 9 9 12 12 12
BLFC (gpm) 0.5 0.5 0.5 0.5 0.5
Injector Size G-GREEN G-GREEN H-ORANGE H-ORANGE H-ORANGE
Injector Draw Rate (gpm) @ 50 psi 1.8 1.8 2.3 2.3 2.3
Injector Slow Rinse (gpm) @ 50 psi 2.5 2.5 3.4 3.4 3.4
*Service flow rates are with hub and lateral type of distributor and may be lower with a stack type of distributor.
H150 Specifications
* Calculations are based on factory medium salt setting @ 50 psi