Heat & Glo LifeStyle XLR-PB-CE Indoor Fireplace User Manual


  Open as PDF
of 65
 
Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/1248
Non-Combustible Finish Material 0-10 cm Thick
Bottom Joint
1,9 cm
1,9 cm
4,6 cm
Figure13.9NoncombustibleSurfaceFinishingMaterial0-10
cmThick-InsideFitMethod(TonicDecorativeFront
Only)
Figure13.8InsideFitMethod(TonicDecorativeFrontOnly)
Non-CombustibleFinishMaterials
0cmto10,16cmThickInsideFitMethod
The Tonic decorative front is approved for inside t appli-
cations. Non-combustible nishing materials up to 10,16
cm thick can be installed around the front (left, right, top,
and bottom).
For the Tonic decorative front inside t applications, the
decorative front must be installed tight to the nishing
anges and must not overlap any nish material.
Ensure that no non-combustible nish materials are in-
stalled within 1,9 cm of the replace opening. The 1,9
cm spacing is required to provide clearance for removing
and installing the Tonic decorative front. See Figure 13.9.
FACTORY-INSTALLED
NON-COMBUSTIBLE
BOARD
DRYWALL OR
EQUIVALENT
(1,3 cm)
52 cm APPLIANCE
OPENING (HEIGHT)
1,9 cm
4,6 cm
0-10 cm
0-10 cm
 previous next