Heat & Glo LifeStyle Exclaim-50 Indoor Fireplace User Manual


 
45
Firebox
Repack
insulation
knockout
Combustible
materials
Maintain air clearance
to combustibles.
Gas line
Combustible materials
may be located at zero
clearance to gas line
beyond 4 in. (102 mm)
from fireplace side.
Gas line
1 1/2 in. (38 mm)
air space around
pipe
Refractory
Seal with
fireplace mortar
or non-combust-
ible sealant
4 in.
(102 mm)
Outer shell
of fireplace
 



WARNING! Fire and/or Asphyxiation Risk! Use with
solid wood fuel or decorative gas appliance only. Gas re
generates fumes.
DO NOT install unvented gas logs
Damper must be locked fully open when gas logs are
installed
A certied gas log lighter or decorative gas log set can be
installed in this replace.
Maximum input is 100,000 BTU/hr.
Decorative gas appliance must be certied to 
 “Standard for Decorative Gas Appliances for
Installation in Vented Fireplaces”.
Must be installed in accordance with the 

A gas log set must incorporate a gas shutoff.
Gas log set requires the damper to be locked fully
open.
A listed automatic damper system with safety interlock
may be used in this replace with only compatible,
listed gas log sets. See damper system manufacturer’s
insturctions.
Knockouts are provided on both sides of the replace
and in refractories for 1/2 in. (13 mm) iron pipe.
Seal refractory around pipe with replace mortar or a
non-combustible sealant.

WARNING! Risk of Fire! Improper installation of wood in-
serts may cause replace or chimney system to overheat.
If a wood burning insert is being installed in this replace,
Hearth & Home Technologies recommends full reline of
the chimney.
Cooling air openings at the top of the chimney must not
be obstructed in any manner.
Hearth & Home Technologies recommends securing the
reline at the top of the ue and using the cap certied for
use with this replace system.
Heat & Glo • EXCLAIM-50 • 4013-041 • Rev AA • 7/12