Filter
Top Products
Heat & Glo • Escape-I35-C, Escape-I30-C • 2201-901 Rev. H • 5/12 38
Log #3 (SRV2202-704): See Figure 2 for additional reference details. Locate the log slot on the bottom right end of Log
#3. Mate the log slot with the left log pin. Rotate the left end of the log counterclockwise, until it contacts the grate tine.
Log #4 (SRV2202-703): See Figure 2 for additional reference details. Locate the log slot on the bottom left end of log #4.
Mate the log slot with the right log pin. Rotate the right end of the log clockwise, until it contacts the grate tine.
Figure 5. Log #3
Figure 6. Log #4
3
4
Log #2 (SRV2202-701): See Figure 2 for additional references. Position Log #2 as shown in Figure 4. Mate Log #2 with
the right corner of the burner as shown. Pull the log forward and to the left until it locks into position.
LOG CONTACTS LEFT
LOG CONTACTS LEFT
GRATE TINE
GRATE TINE
LOG CONTACTS RIGHT
LOG CONTACTS RIGHT
GRATE TINE
GRATE TINE
FLAT SPOT
FLAT SPOT
FOR LOG#6
FOR LOG#6
Figure 4. Log #2
LOG HANGS OVER
LOG HANGS OVER
ONTO BURNER TOP
ONTO BURNER TOP
2
2
1
1
Figure 7. Glass Rock in Place
GLASS ROCK
GLASS ROCK
LOG MATES
LOG MATES
WITH CORNER
WITH CORNER
OF BURNER
OF BURNER
Glass Rock (2201-853): Once Log #3 and Log #4 are installed, fi ll each light tray with the glass rock.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.