Filter
Top Products
R
R
R
September 1, 2008
7001-142D
Page 7
Santa Fe Pellet Stove
G. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
WARNING
Figure 37.1
1.
Open the face and remove door from the appliance by
lifting door off of hinge pin and lay on a at surface face
down.
2. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the
rod will slide up. Swing the rod toward you from the
bottom and remove the rod. Repeat for other side.
. Remove old glass and replace with new glass.
4. Slide the retainer rod into the top hole rst, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be paralle with the glass
in order to insert it into place. Figure 35.1.
Rope Retainer
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
Glass