Filter
Top Products
R
R
R
September 1, 2008
7001-142D
Page 17
Santa Fe Pellet Stove
7
Appliance Set-Up
A. Outside Air Kit Instructions
Flex Hose
Hose Clamp
Collar Assembly
Trim Ring
Termination
Cap Assembly
Hose Clamp
Air Intake Channel
Parts Included in Kit: 1 piece of 2 inch x foot ex hose,
2 hose clamps, 1 collar assembly, 1 termination cap assem-
bly, 1 trim ring, 12 screws. (Discard collar assembly and air
channel, collar assembly already on appliance).
1. Measure distance from oor to air vent opening in stove
and mark location on wall.
Use
saw to cut opening in wall. Cut a 2-1/2 to inch
(64-76mm) opening on inside wall and a to -1/2 inch
(76-89mm) opening on outside of house.
2. Use hose clamp to secure ex pipe to collar assembly.
. Slide trim ring over ex pipe and run pipe through wall.
4. Attach hose to outside termination cap with second
hose clamp.
5. Secure termination cap to outside surface.
6. Secure trim ring to interior wall.
Tools Needed: Phillips head screwdriver; wire cutters; hole
saw or jig saw.
CAUTION
Never draw outside combustion air from:
• Wall, oor or ceiling cavity
• Enclosed space such as an attic or garage
Figure 17.4