Filter
Top Products
R
R
R
September 1, 2008
7001-142D
Page
Santa Fe Pellet Stove
1. Convection Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. The Convection Blower is located on the oor at the
rear of the appliance.
c. Remove the right lower side curtain by releasing bracket
from attachment holes in the back and then swing it to
the front and lift off of the appliance. When re-installing
ex curtain to re-attach. Figure 33.1.
d. Cut the tie wire holding the wires togehter and then dis-
connect the yellow and purple wires.
e. Re-install in reverse order.
f. Attach new tie wire to hold wires together.
C. Blower Replacement
2. Exhaust Blower Replacement
a. Turn down the thermostat, let appliance completely cool
and then unplug appliance before servicing.
b. Remove both lower side curtains. Figure 33.1.
c. Remove the lower rear screen and lay at, leaving all
wires still attached.
d.
Remove the upper rear screen from the appliance by
removing 2 screws at the top, 1 in the center and 2 screws
on the sides at the top. Leave both upper side curtains still
hinged in place to the rear screen. Figure 33.3.
e. Remove the 2 screws holding the vacuum switch in place.
Disconnect vacuum hose and blue and white wires from
the vacuum switch.
f. Remove the 2 screws holding the junction box in place.
e. Disconnect the white and blue wires from the exhaust
blower.
f. There is a removable plate on the exhaust blower. Using
a 1/4” nutdriver loosen the 6 screws in the keyhole shaped
holes and rotate the plate. Figure 33.4
g. Remove the exhaust blower and gasket.
i. Re-install in reverse order.
Figure 33.3
Figure 33.2
Remove lower
right side curtain
Flex curtain and
snap brackets into
attachment holes
Back of Stove
Pull blower up of the locating
pins and pull towards you.
Convection
Blower
Exhaust
Blower
Figure 33.1
Tabs at bottom of upper rear screen
Remove 2 screws, 1 on each side
Junction Box
Screws
Metal Strip
inside Hopper
Lower Rear Screen
Figure 33.4