Filter
Top Products
R
R
R
September 1, 2008
7001-142D
Page 19
Santa Fe Pellet Stove
D. Optional Log Set Placement Instructions
Figure 19.1
4 PIECE LOG SET INSTALLATION
OPTIONAL TOP LOG
Figure 19.2
Figure 19.3
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance re, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
1. Place the right rear log as shown. There is a notch in the
bottom of the log for clearance for the thermocouple and
thermocouple cover (ceramic protection tube). Figure
19.1.
2. Continue placing the last logs around the repot as
show in Figures 19.2, 19.3 and 19.4. Be careful not to
block the drop tube in the back of the rebox where pel-
lets feed into the repot.
Place the top log over the repot. It will be about
2-
1/2 inches (64mm) above the repot when in
place. Notice the position of the top log as it rests
on the logs in a stable position to prevent it from
falling into the repot.
The charred area on the back of the top log faces
the back, not the front. Figure 19.5.
Drop Tube
Notch
Thermocouple
Cover
Figure 19.4
Figure 19.5
Figure 18.3 - Rear Vent Adapter