Filter
Top Products
Page 6
7001-142D
September 1, 2008
Santa Fe Pellet Stove
R
R
R
F. Bafe & Brick Replacement
Right Brick Installed
Brick is flush against back wall
Brick in
front of
clip and
Notches
exposed
Lift Brick, pull forward at an angle
and drop down into notches
Opening at left side of Baffle
Tabs
Do not remove rope
from center brick
Figure 36.1
1. Place right brick in behind the right bracket and then
slide to the left so the tabs are behind the center brick.
Figure 36.1.
2.
The brick will be ush against the back wall and the
braket’s notches will be exposed. Figure 36.2.
. Pull the right edge of the brick forward and slide the
brick into the notches both top and bottom of right
bracket. Figure 36.3.
4. Repeat for left brick.
5. Insert bafe into top front of rebox and then raise up
the bottom end and insert bafe tab into notch on the
right bracket to lock into place. Figure 36.5. Place the
left side hook of the bottom bafe over the top of brick
for stability.
6. The bafe does not completely cover the top of the re-
box. There is an opening as shown in Figure 36.6.
Insert Baffle Tab into Slot
Figure 36.2
Figure 36.3
Figure 36.4
Figure 36.5
Figure 36.6