Filter
Top Products
Page 18
7001-142D
September 1, 2008
Santa Fe Pellet Stove
R
R
R
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
1. Put a layer of high temperature silicone on the
inch (76mm) exhaust outlet. Figure 18.1
2. Slide the top vent adapter onto the rear exhaust
outlet and adjust the assembly to a vertical position.
Figure 18.1
. Drill 4 holes with #26 drill bit (provided) into the
back of the appliance using the outer shield as
a pattern (make sure the assembly is vertical).
Figure 18.2
4. Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear
exhaust outlet using the 2 holes already in the short
horizontal pipe in the top vent adapter as a guide.
Install the 2 screws. Figure 18.1
6. Install the vent pipe into the top vent adapter (be
sure to silicone all joints).
7. To clean the top vent adapter open the clean-out
cover. Figure 18.2.
B. Top Vent Adapter Installation
Use hole on each side as
drilling guide
to 6 in.
Offset
Adapter
Silicone
Rear Exhaust
Outlet
to in.
Top Vent
Adapter
Drill holes in back of
stove and secure
with 4 screws, 2 on
each side
Clean-Out Cover
Figure 18.2
Figure 18.1
Installing the Top Vent Adapter
C. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Clean-Out Cover
Clean-Out Cover
Figure 18.3 - Rear Vent Adapter
Figure 18.4 - Rear to Top Vent Adapter - 90
o
1. Put a layer of high temperature silicone on the inch
(76mm) exhaust outlet. Figure 18.1.
2. Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
. Install the vent pipe into the adapter (be sure to silicone
all joints)