Filter
Top Products
R
R
R
September 1, 2008
7001-142D
Page 5
Santa Fe Pellet Stove
D. Igniter Replacement
E. Bafe & Brick Removal
1. Shut down the appliance by turning down the thermostat
and let the appliance completely cool down. After the
appliance has cooled down, unplug it and remove the
ash drawer.
2. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections and remove the
igniter from the chamber. Loosen thumb screw and
slide igniter out.
. Install new igniter into the chamber and tighten thumb
screw. Re-connect the wires to the 2 leads with the
spade connectors.
4. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod,
cleaning slide plates, etc.
5. Re-install the ash drawer and side panel and re-connect
the power.
Thumb Screw
Igniter
Firepot
Figure 35.1
Figure 35.2
Figure 35.3
1. Appliance must be completely cool.
2.
Open door and locate the bafe at top of inside of rebox
.
.
The bafe is secured to the right bracket. A tab on the
bafe is inserted into a notch on the right bracket. Lift the
bafe up, out of the notch and towards you. Figure 35.2.
The left side of the bafe has a hook that rests on the top
edge of the brick. This side will just lift off.
4. Remove right brick by pulling up and then towards you to
expose the exhaust venting for cleaning. Figure 35.3.
Hook on
left side
Tab on
right side