Filter
Top Products
Heat & Glo • Paloma • 7031-220 Rev. P • 10/08 37
I. Positioning the Logs
Remove the ignitor shield from the pilot assembly prior to
installing the logs. (Figure 8.18).
Figure 8.19
H. Installing the Baffl e
The baffl e is shipped wrapped, inside the fi rebox. Install
the baffl e with the embedded “T” side up, place it on top
of the brackets on the inside of the fi rebox, ensuring back
edge of baffl e makes contact with the back of the fi rebox.
Figure 8.17
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
Figure 8.18
Figure 8.20
PILOT ASSEMBLY
PILOT ASSEMBLY
IGNITER SHIELD
IGNITER SHIELD
Note: Logs have been designed to work specifi cally with the
burner of this appliance. Exact placement will ensure proper
operation of your gas appliance.
Place log #1 into the cradle in the burner. Lean the log
back towards right corner of firebox.
Locate log #2 over the pin in log #1 and into notch in log
#1. Lean the log back toward the left corner of the fire-
box.
PIN
PIN