Hearth and Home Technologies NorthStar-NT Indoor Fireplace User Manual


  Open as PDF
of 72
 
Page 42
Heat & Glo • NorthStar EPA Fireplace • 480-1081C
September 1, 2008
September 1, 2008
September 1, 2008
TOOLS NEEDED: Powered drill with #2 Phillips head bit;
caulking gun.
1in.(25mm)OVERLAP
Metal strips 2 in. (51mm) under edge of
Fireplace and Hearth Extension and 2 in.
(51mm) on both side of fireplace opening.
Nail or screw metal strips in place.
Seal with
non-combustible
sealant
Top
Board
Bottom
Board
Side
Board
Side
Board
Tabla superior
Tabla lateral
Tabla inferior
Tabla lateral
Aplique Super Calstick en el extremo
FIGURA A
FIGURA B Instalación completa del material
de revestimiento incombustible
#7014-063, 5 de enero de 2006 Página 1 de
1
Apply bead of
Super Calstick to
edge here
1. Securethereplacetotheoororwallframingstudsat
a minimum of two attachment points to prevent further
movementofthereplace.ThesameholesandLbrack
-
etsthatattachedthereplacetothepalletmaybeused
tosecurethereplacetothesubooringbyusingamini
-
mumoftwo1/4in.x2in.lagboltsorequivalent.
Refer
to Figure 42.1 and install the two metal hearth strips at
this time.
NOTE: All boards are pre-drilled for your convenience.
Boards MUST be attached in the following order:
bottom, top, and then the two sides.
2. Attachthebottomboardtothebottomoftheouterre-
place can with enclosed screws, ensuring the board is
centered.
3.
Center and attach the top board to the outer can and
framing members.
4. UsingtheSuperCalstick,runalightbead(1/8in.mini-
mum) on the butt edges of the top board. See Figure
42.2.
5. Ensuring the top of the side pieces and the top board
align, attach the side pieces to the outer can and framing
members.
6. Use a wet or dry towel or a soft brush to remove any
dust or dirt from facing material. Apply a non-combustible
adhesivetoattachtile,stoneorothernon-combustiblen
-
ishing materials per manufacturer’s instructions.
7. The non-combustible Super Calstick may be used for
sealingbetweenthereplaceandthehearthextension.
Refer to Figure 42.3.
E. Non-Combustible Facing Material
Installation
Figure 42.1
Figure 42.2
Figure 42.3
Figure 42.4 Complete installation
Risk of Fire.
•
Follow these instructions exactly.
• Facing materials must be installed properly
topreventre.
• No materials may be substituted
without authorization by Hearth & Home
Technologies.
WARNING
 previous next