Filter
Top Products
September 1, 2008
September 1, 2008
Heat & Glo • NorthStar EPA Fireplace • 480-1081C
Page 29
Storm Collar
Flashing Collar
Top of Pipe
14-1/2 in. (368mm) max.
1-1/2 in. (38 mm) min.
overlap
2 in. (51 mm) min.
Figure 29.1 Installing a TR342 Round Telescoping Termination
Cap
2 in. (51 mm) min.
4-1/2in.
(114 mm)
max.
1-1/2in.
(38 mm) min.
overlap
Cap Standoff
Top of Pipe
Flashing Collar
Figure 29.2 Installing an ST375 Square Termination Cap
Top of Pipe
2 in.
(51 mm)
min.
Flashing
Collar
1-1/2 in.
(38 mm)
min.
overlap
3 in.
(76 mm)
max.
Figure 29.3 Installing a TS345/TS345P Square Termination Cap
• For installations utilizing an ST375 Square Termination
Cap the last chimney section must not be more than
4-1/2in. (114mm) belowthe chasetop.See Figure
29.2.
• For installations utilizing aTS345/TS345P Square
Termination Cap, the uppermost chimney section must
not be more than 3 in. (76 mm) below the chase top. See
Figure 29.3.
•
For installations utilizing a Terra Cotta Cap the last chimney
section must be between 7 in. (178 mm) below the chase
top and 2 in. (51 mm) above. See Figure 29.4.
• For chase installations you can use a Round Termination
Cap, a Round Telescoping Termination Cap, a Square
Termination Cap, or a Terra Cotta Termination Cap.
• For installations utilizing a European Copper Series
Termination Cap, See Figure 29.5.
• Install termination caps following instructions provided
with them.
chimney top
2 - 6 in.
(51-152 mm)
2 in. (51 mm)
typical
chase
top
(metal or masonry)
Cap Base
(cap inner flue)
SL pipe
inner flue
screw (8)*
bracket (8)
Figure 29.5 Installing a European Copper Series Termination Cap
(CT3-King shown)
The last section of pipe
must stop between the
distances given below.
2 in. (51 mm) above top
of the chase.
7 in. (178 mm) below top
of the chase.
{
Top of Pipe
1-1/2 in. (38 mm)
min. overlap
Figure 29.4 Installing a TCT375 Terra Cotta Cap
NOTE: TR342/TR344:Forlessairrestrictiontoue
gases, use top vent kit listed in Section 12.