Filter
Top Products
27
SECT 7—SETTINGS
(FORCE & LIMITS) FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
Fig. 7-1
1. Set limit switch position.
• Check door fully closed.
– If not, close door manually.
• Check carriage is between limit switches.
–
If not, move “CLOSE” limit switch (brown wire)
to new position between door and carriage.
– Slide “CLOSE” limit switch back toward
carriage until lever is fully lifted. Fig. 7-1.
–Tighten limit switch set screw.
• Manually open door to fully open position..
• Check carriage is between limit switches.
– If not, move “OPEN” limit switch to new
position between power head and carriage.
– Slide “OPEN” limit switch back toward
carriage until lever is fully lifted. Fig. 7-1.
–Tighten limit switch set screw.
2. Adjust opening force.
• Engage Carriage by pulling Emergency
Release Lever toward Powerhead until
Lever snaps into engaged position.
• On front panel of power head—find adjusting
screw marked “CLOSE.” Fig. 7-2.
•
Turn screw gently counterclockwise until it stops.
NOTE:
Little force required to move adjusting screws.
• Run operator using wall control.
•Observe door runs to “CLOSE” limit switch.
– If not, increase closing force by turning
“CLOSE” adjusting screw clockwise slightly
(about 1/16 turn).
• Repeat until door runs to “CLOSE” limit switch.
• Check door is fully closed.
– If not, move “CLOSE” limit switch toward
door as necessary to achieve fully closed.
3. Adjust closing force.
• On front panel of power head—find adjusting
screw marked “OPEN.” Fig. 7-2.
•
Turn screw gently counterclockwise until it stops.
• Run operator using wall control.
•Observe door runs to “OPEN” limit switch.
– If not, increase opening force by turning
“OPEN” adjusting screw clockwise slightly
(about 1/16 turn).
• Repeat until door runs to “OPEN” limit switch.
• Check door is fully open.
–
If not, move “OPEN” limit switch toward power
head as necessary to achieve fully open.
Door opens rapidly
•Keep clear of door and its path.
•Keep ladder to side of power head to
prevent being hit by moving parts.
Be sure and set force adjustments at minimum
required to operate door.
CAUTION
Fig. 7-2
CLOSE
OPEN
CARRIAGE
SLIDE
SWITCH
lever
(actuator arm)
fully lifted
NOTE:
When the garage door is closing and
contacts a vehicle or other obstruction, the
contact reverse mechanism may not
prevent damage to the obstruction, garage
door or garage door operator.