Filter
Top Products
1-PIECE DOOR
21
INSTALLATION
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
10. Attach door arms [23] and [26].
• For sectional doors.
– Connect short leg of curved arm to
door bracket. Fig. 2-14.
– Use clevis pin [24] and cotter pin [25].
Fig. 2-14.
– Connect straight arm to carriage.
– Use clevis pin [24] and cotter pin [25].
– Overall length of arms together should be
as short as possible, but must not be so
short that they are vertical when the door
is fully closed. Fig. 2-14.
a. Move carriage as necessary to
adjust length.
b. Place bolts [27] and nuts [28] as far
apart as possible. Fig. 2-14.
c. Tighten bolts and nuts.
• For 1-piece doors.
– Connect short leg of curved arm to
carriage. Fig. 2-14.
– Use clevis pin [24] and cotter pin [25].
Fig. 2-14.
– Connect straight arm to door bracket.
– Use clevis pin [24] and cotter pin [25].
–Overall length of arms together should be
as long as possible. Fig. 2-14.
a. Move carriage as necessary to
adjust length.
b. Place bolts [27] and nuts [28] as
close together as possible. Fig. 2-14.
c. Tighten bolts and nuts.
11. Adjust emergency release knob height.
• Knob should hang approximately 6 feet from
the floor.
– adjust as necessary to clear vehicles yet
maintain height where it can be
easily reached.
• Pull cord through lever until knob is at
desired height.
•Tie a new knot at the lever.
• Cut off excess cord.
Fig. 2-14
SECTIONAL DOOR
clevis & cotter pin
clevis & cotter pin
must be
some angle
off vertical.
—bolts/nuts (far apart as possible)
—bolts/nuts (close as possible)
Cotter pin
Clevis pin
3/8" Hex head bolt
3/8" Nut
[
24
]
[
25
]
[
27
]
[
28
]
OPEN YELLOW PARTS BAG