Filter
Top Products
5
2.5 To set the room temperature
2.5.1 Following on from section 2.4, once the room temperature
is flashing on the display, it can be set.
2.5.2 Press either the ( ) button (10) or the ( ) button (13) to
either increase or decrease the temperature.
2.5.3 Press the SET button (12) once you have set the
temperature as desired.
If the SET button (12) is not pushed the temperature display
will stop flashing and remain unchanged.
2.6 To change from Automatic to Manual
mode.
2.6.1 The hand set display will show AUTO (8).
2.6.2 Press the SET button (12) once and the word MANUAL will
flash.
2.6.3 Press the SET button (12) again and the word
MANUAL will stop flashing.
You are now in Manual mode.
2.7 Low battery display (Hand Set)
The low battery symbol (6) will appear on the hand set
when the batteries require replacement.
2.8 Lighting the Linea (Touch Pad)
2.8.1
Press the ON / OFF button (1) once and the red LED will
flash. The pilot will now light. This should take about 10
seconds.
If the pilot does not light press the ON / OFF button (1)
again to reset the control unit and repeat step 1 above.
Before the burner can be lit wait for the audible click.
2.9 To adjust the flame height (Touch Pad)
2.9.1
Once the pilot has lit press the ( ) button (2) and the
burner will light.
2.9.2
Press either of the ( ) buttons (2/3) to adjust the height
of the flames.
2.10 To turn the Linea off (Touch Pad)
2.10.1
Press the ON / OFF button (1) once and the Linea will turn
off.
ENSURE THE APPLIANCE IS COLD BEFORE PROCEEDING.
3.1 The outside casing of the Linea should be cleaned using a
damp cloth.
3.2 To clean the glass panel, remove the decorative front as
detailed in the instructions supplied with front.
3.3 Remove the glass panel by unscrewing the nine pozidrive
screws. See diagram 3
3.4 Use a damp cloth and warm soapy water. Ensure the glass is
dry before re-assembling.
3.5 Ensure that the fibreglass seal on the firebox is intact then
hook the location tabs over the hooks on the top of the
firebox. Replace the nine screws working from the top
down, three long ones in the bottom holes. Tighten the
screws evenly.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
PANEL IS REMOVED OR BROKEN.
3. CLEANING THE LINEA
USER INSTRUCTIONS
2
3
AR1339