Filter
Top Products
6
7.4 Place log D across from the rear log A to log B on the left-
hand side. There are cut-outs in both logs for location. See
diagram 5.
7.5 There are two ash panels which lay across the front of the
burner skin. Place the panel with the flat edge facing the left
side of the firebox. There are location holes on this log
which fit over the screw holes of the burner skin.
7.6 Place the second ash panel to the right of the first, with the
pointed end of the panel fitting into the V shape. This panel
should locate on the screw holes of the burner skin. Ensure
that both logs are horizontal to the burner ports.
7.7 Place log E across from the rear of log A to log C on the right
hand side. Again, there are cut-outs for location. The front of
the log should sit on the front ash panels and should fit tight
to log C. See diagram 8.
7.8 Carefully insert the front coal retainer into the front panel of
the firebox. Take care not the scrape/damage the logs. This
coal retainer sits in two brackets. Ensure it is fully inserted,
leaving approximately a 4 mm gap between the firebox
ledge and the bottom of the coal retainer.
7.9 Ensure that the fibreglass seal on the back of the door is intact,
locate the door on the four studs and slide back to the
firebox. Secure in place using the four dome nuts and tool
supplied. Do not overtigthen the nuts, see diagram 10.
NEVER OPERATE THE STOVE WHEN THE DOOR IS
REMOVED.
USER INSTRUCTIONS
5
AR1613
6
AR1614
7
AR1615
8
AR1616
9
AR1617
10
AR0540