Filter
Top Products
5.4 Place the second ash panel to the right of the first, with the
pointed end of the panel fitting into the V shape. This panel
should locate on the screw holes of the burner skin. Ensure
that both logs are horizontal to the burner ports.
5.5 Place log E across from the rear of log A to log C on the right
hand side. Again, there are cut-outs for location. The front of
the log should sit on the front ash panels and should fit tight
to log C. See diagram 15.
5.6 Carefully insert the front coal retainer into the front panel of
the firebox. Take care not the scrape/damage the logs. This
coal retainer sits in two brackets. Ensure it is fully inserted,
leaving approximately a 4 mm gap between the firebox
ledge and the bottom of the coal retainer.
AR1615
18
5.7 Ensure that the fibreglass seal on the back of the door is
intact, locate the door on the four studs and slide back to
the firebox. Secure in place using the four dome nuts and
tool supplied, do not overtigthen the nuts, see diagram 17.
NEVER OPERATE THE STOVE WHEN THE DOOR IS
REMOVED.
6. LIGHTING
6.1 Full instructions are given in the User section under Lighting
the Stove.
INSTALLATION INSTRUCTIONS
INSTALLATION
14
15
AR1616
16
AR1617
17
AR0540