Filter
Top Products
Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)
58
www GarrettCom com
..
TX RXL
ACT
F/
TX LK RX
ACT
F/
TX RXLK
ACT
F/
The GBIC transceiver has been offered in the modular slot with multiple options as per
the user requirement. The two Giga port has been offered as GBPM-2OTX (fiber or RJ-
45), whereas the single Gigabit module comes in two different flavor of G+2 (100Mb
fiber ports) or G+4(10/100 RJ-45 ports) as shown in the above figure.
The GBIC transceiver is fastened using snap-in clips. Insert the transceiver
(take care to insert it the right way up, arrows on top) until it clicks in space. While
removing the transceiver, press the clips on either side of the transceiver at the same time
and pull the transceiver out.
Each port has an Activity (ACT) LED indicating packets being received and a
Link (LK) LED indicating proper connectivity with the remote device when lit.
5.2.13a GBIC-LXSC Gigabit fiber (1000Mb), multi-mode SC Connector
The Magnum GBIC-LXSC is a single-mode Gigabit fiber connector equipped
with SC type connectors and can be easily snapped in and out. The Gigabit fiber ports are
most popular as server-to-switch and switch-to-
switch applications. It supports cable distances up
to the IEEE 802.3z standard 1000Mbps distance
limits, i.e., 10,25, 40 or 70Km at full duplex, and
depend upon the Gigabit modules used.
1@ 1000Mb Fiber SC + 2@ 100Mb SC
The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), whereas the single
Gigabit module comes in flavors of
G+4(10/100 RJ-45 ports) or G+2
(100Mb fiber ports) as shown below in
the above figure.
Each port has an Activity (ACT) LED
indicating packets being received and a
link (LK) LED indicating proper
connectivity with the remote device