Filter
Top Products
Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06)
55
www GarrettCom com
..
ports on one module. The 6KP8-45LC is equipped with 4 10/100 RJ-45 ports and 4 LC (
Small form factor) multi-mode fiber ports.
When installed in a Magnum 6K16-Series Switch, it supports the standard distances as
per mentioned on 5.2.8. and the LEDs also acts similarly as mentioned above.
5.2.9 6KP8-RJ45 (Twisted Pair), 10/100Mb 8-Port
The 6KP8-RJ45 module supports Ethernet twisted pair segments of any
standard length. It is equipped with an eight-port RJ-45 connector, and offers 10/100 full
/ half-duplex auto-
negotiating capability on
each port. The RJ-45
connector is shielded to
minimize emissions and will
allow both unshielded
twisted pair (UTP) and
shielded twisted pair (STP)
cable connections. The
6KP8-RJ45 module is
equipped with a Media
Dependent Auto-Crossover
(MDI-X) switch, which controls all ports for cascaded connection. This feature
eliminates the need for a special twisted pair crossover cable when connecting to a hub or
another switch.
Each port has an Activity (ACT) LED indicating packets being received, a
Link (LK) LED that indicates proper connectivity with the remote device when lit, a
FDX/HDX LED to indicate full-duplex mode when lit (or half-duplex when off), and a
“10/100” LED indicating 100Mb when lit (or 10 Mbps when off).
Important Note: The 10/100 RJ-45 ports are supported with Auto-negotiation and
Auto-crossover (MDIX), which allow the RJ-45 ports to automatically Link with any RJ-
45 device and eliminate the use of cross-over cable.
NOTE: for Power Substations
: In support of the IEEE 1613 Class 2 standard, GCI
advises that, for substation applications, the RJ-45 ports are intended for
connectivity to other communication equipment such as routers or
telecommunication multiplexers installed in close proximity (i.e., less than 2
meters or 6.5ft) to the 6K16(V). It is not recommended to use these ports in
substation applications to interface to field devices across distances which
could produce kigh (greater than 2500V ) levels of ground potential rise (GPR)
during line-to-ground fault conditions. The 6K16(V) passes the
1613specifications for zero packet loss with fiber ports & with RJ45 ports used
as indicated here.
6KP8-RJ45,
8 Port@ 10/100Mb Copper ports
4
4
FULL/HALF
1
ACTIVITY
LINK
2
3
10/100
2
1 3 5 7
10/100
LK
1
3
F/H
ACT
10/100
LK
2 4 6 8
F/ H
ACT