Filter
Top Products
ECONOMICmode
PresstheECONOMICkeytoactive
theECONOMICmode.Pressthis
buttonagaintodeactivateit.
In the cold and dry modes:
- The indoor unit fan can be set on
low speed.
- After one hour of operation, the
adjusted temperature will increase
1°C (34°F). After one hour, the
temperature will increase another
1°C (34°F). The unit will continue
to operate 2°C (36°F) above the
adjusted temperature.
In heating mode:
- The indoor unit fan can be set on
low speed.
- After one hour of operation, the
adjusted temperature will drop 2°C
(36°F). After one hour, the
temperature will drop 2°C (36°F)
once again. The unit will continue
operating 4°C (39°F) below the
adjusted temperature.
i 1°c I
X,' _ 1 °C
E
I _houri 1hour I
ECONOMIC operation - Cooling
_=
4 1°C
--iT, oc
I
1hour I 1hour I 7hours
l
ECONOMIC operation - Heating
TIMER Operation
Push TIMER ON button to set the auto- on time and TIMER OFF button to set
the auto-off time.
To set the starting time
1. Push the TIMER ON button, then the remote controller shows TIMER ON,
the last set time for the starting operation and the signal "h" will be shown
on the DIGITAL DISPLAY area. You are now ready to reset the time to START
the operation.
2. Push the TIMER ON button again to set desired unit start time.
3. After setting the TIMER ON ,there will be a one-half second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" disappears and the set
temperature witl re-appear on the digital display.
To set the stopping time
1. Push the TIMER OFF button and the remote controller will show TIMER OFF,
the last set time for the stopping operation and the signal "h" will be shown
on the DIGITAL DISPLAY area. You are now ready to reset the time of the
STOP operation.
2. Push the TIMER OFF button again to set the time you want to stop the
operation.
3. After setting the TIMER OFF ,there will be a one-half second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" disappears and the set
temperature will re-appear on the digital display.