Filter
Top Products
Optional Equipment (for qualified installers only) 47
Travis Industries 4050114 100-01149
LP Conversion Instructions
Install the
conversion kit prior
to installing the gas
line to ensure
proper gas use.
1 Remove the glass
(see page 29).
Remove the logs (if
installed - page 31)
2 Remove the burner
(see illustration to
the right).
a
c
Lift the pilot hood off the pilot
assembly (you may need to
pull hard to remove).
Remove the ember shelf.
b
Lift the right side of the
burner then slide the burner
to the right until the orifices
disengage from the burner.
Remove the burner from the
firebox.
Do not lift the burner by
the pins.
NOTE:
Make sure the burner is
fully seated. When in
place, the pilot flame
must align directly above
the burner holes.
Slide the air shutters all the
way to the left before
installing the burner.
Make sure the mixing tubes
slide onto the orifices.
Make sure this pin inserts
into the hole in the
bottom of the burner.
Mixing Tubes
Orifices
Replace the pilot hood
after replacing the burner.
Burner Replacement:
Make sure the burner is fully seated.
When in place, the pilot flame must align
directly above the burner holes.