Filter
Top Products
Operation 37
Travis Industries 4050114 100-01149
Before You Begin
Warning: Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass
should be done by a licensed or qualified service person.
Location of Controls - See explanation below
Gas
Control
Valve
Gas Control Knob
Flame Adjust Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
The pilot flame is located
below the rear log.
ON
OFF
BURNER
On/Off Switch
IGNITER
Pilot Igniter
BLOWER
OFF
Blower Knob
HI
Open the
access door to
view the
controls.
LO
Blower Knob This knob controls the speed of the internal convection blower that pushes the
heated air into the room.
On/Off Switch This control is used to turn the fireplace on and off.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an electrical
charge to the pilot assembly. This creates a blue spark directly next to the pilot,
igniting the pilot flame.
Gas Control Knob This knob controls gas to the burner and pilot. There are three positions: ON, OFF,
and PILOT. The indicator line is to the left of the knob.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI”). The indicator line is
above the knob.
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off Switch "OFF"
will keep the fireplace off always.