Filter
Top Products
28
Secondary Installation
OPTIONAL CERAMIC BRICK PANEL INSTALLATION:
Baffle
Ledge
Turn off the gas control knob and allow the
unit to cool.
Please ensure that your ceramic panels have not
been damaged.
To Install Panels:
1. Remove the glass door by following the
instruction in the “SECONDARY INSTALLATION -
GLASS DOOR REMOVAl” section and remove logs if
necessary.
2. Slide center brick panel up behind the bafe
(shown in Figure 41) and rest the bottom of the
panel on the ledge.
Figure 41. Back Panel In Place.
Figure 42. Right Panel In Place.
Figure 43. Top Tab For Right Panel. Figure 44. Bottom Tab For Right Panel.
the top right tab tight against the top of the panel (see Figure
43).
6. Repeat steps 4 and 5 for the left panel.
7. Install the log set (refer to SECONDARY INSTALLATION - LOG SET
AND EMBER INSTALLATION) and glass door.
To Remove Panels:
1. Pull the bottom and top tabs away from the side panels.
2. Carefully slide the side panels out towards the front, do not
slide the panels on the tabs.
3. Push the center panel straight up about inch ( cm), pull
the bottom out past the ledge, then pull the panel down until it
is past the bottom of the bafe. Remove panel from rebox
3. Using a at head screwdriver, bend the top tabs on either side at the front of the bafe down (refer to
Figure 43 for placement).
4. Slide the right panel along the side of the rebox until it is tight against the right side of the center
panel. Ensure the panel is behind the top tab (see Figure 42).
5. Bend up the right bottom tab until it touches the bottom of the right panel (see Figure 44) and press