Filter
Top Products
27
Secondary Installation
Figure 39: Once the logs are in
place the embers can be placed
onto and around the burner to
create a realistic look. Bags of
ceramic ber embers and rock
wool are provided. The ceramic
ber comes in chunks that are
about 2 inches (5.1 cm) long.
Place them irregularly around
the burner. When there is a
sparse but even layer of embers,
spread the rock wool in the
same manner.
Figure 39. Complete log set-up with embers.
WARNINGS: DO NOT pack this ember material as this could create an unsafe condition. The pieces
should be lightly placed so they don’t block any of the burner ports. DO NOT allow any of the embers to
rest against the pilot assembly.
Caution: Use only the type of ember material supplied with this replace. Due to the irregular size of
the ember material, there may be more than required. Use of other foreign materials on the burners may
create dangerous conditions.
Figure 40. DV36 complete log set-up with embers burning.
it to cool down. Then remove the glass and rearrange the ember material, making sure none of the
burner ports are blocked.
Maintenance: Once a year, the logs should be removed and checked for deterioration or large amounts
of soot. A small amount on the bottom side of the logs is normal. Remove and replace the logs in the
same manner described above.
If new/more embers and rock wool are required, contact your nearest ENVIRO dealer.
Never operate the replace with the glass door removed.
Figure 40: The DV36
burning with a good
ame.
NOTE: While the glass
is still removed, it is
recommended that the
gas line be purged by
lighting the pilot.
When lighting the
replace for the rst
time since the log set
and embers have been
installed/replaced, watch
for ignition at ALL the
burner ports. If a long
delay is noticed, turn the
appliance off and wait for