Filter
Top Products
Page 6 R-3450
Figure 6
8. Position the completed portion of the casing in the approximate
location for installation as the completed assembly will be heavy.
9. Refer to Figure 7, removing protective packing foam from casing
front and window. Remove the (1) 3/4" bolt and (1) 1/4" washer
from top of window. Remove (1) 3/8" bolt and 1 - 5/8" x 3/4"
retaining tab from bottom of window. Remove the window from
casing front. Remove the protective sheet of foam from the casing
front.
Place the window into the casing front. Attach the top of the
window to the casing front with (1) 1/4" washer and (1) 3/4" bolt.
Place the 1 -5/8" x 3/4" retaining tab into the locator notch on the
bottom of the casing front. Attach the bottom of the window to the
casing front by inserting (1) 3/8" bolt through retaining tab and into
locator notch.
10. Attach the (4) 1-1/4" x 1/2" retaining tabs to the casing front with (4)
3/8" bolts. The retaining tabs should be positioned downward, from
the casing front, top to the casing front, bottom.
11. Refer to Figure 8, attach casing front to outer casing by using the
(4) retaining tabs on the casing front. The (2) top, retaining tabs on
the casing front will be placed behind the (2) top, locator tabs on the
front of the casing sides. The (2) bottom, retaining tabs will be
inserted into the (2) 9/16" slots on the front, leg pads. Place the top,
retaining tabs behind the top, locator tabs as you pivot inward the
bottom of the casing front in order to insert the bottom, retaining
tabs into the slots.
12. The following procedure will provide a snug fit between the casing
front and the casing sides. Grasp the right, front leg, push inward on
the leg in order to provide a snug fit between the casing front and the
casing side. Continue to hold the right, front leg as you completely
tighten the (2) 3/8" bolts that attach the leg pad to the right, casing
side. Repeat procedure for left, front leg to achieve a snug fit between
the casing front and the casing side.
13. Remove the casing front from the outer casing.
Figure 5