Desa (V)DVF36 Indoor Fireplace User Manual


  Open as PDF
of 36
 
www.desatech.com
56131-F24
2. Prepare incoming gas line and check with
local codes regarding the use of teon tape.
Complete your gas line installation by con-
necting incoming gas line with exible gas
line. Secure tightly with a wrench, but DO
NOT OVERTIGHTEN.
    

for leaks after the installation
   
  -
     

-

   


-
-
vice, or maintenance can cause


additional information, consult
   

INSTALLATION
Continued
GAS SUPPLY TESTING
Note: This section is intended as a guide for
qualied service technicians installing gas to the
appliance.
CAUTION: Do not connect
-
 
-

The millivolt system with a manual HI/LO ap-
plies only to the (V)DVF36TPNA/TSDTA and
(V)DVF36TNPA/TSTPA models. The gas control
valve is accessible from the lower control com-
partment. Two pressure taps are provided on the
gas control valve for a pressure gauge connection
(see Figure 44).
O
F
F
P
I
L
O
T
O
N
L
O
H
I
P
I
L
O
T
E A
16AI
7
TPTH TP TH
Figure 44 - Millivolt Control Valve
Pilot
Adjustment Cap
ON/OFF
Knob
Outlet
Pressure
Inlet
Pressure
Pilot Gas Line
Do Not Kink
To Pilot
Burner
To Main
Burner
Flame
Adjustment
Knob
E
A
O
L
H
I
L
P
I
O
T
To Main
Burner
Outlet
Pressure
Inlet
Pressure
Flame
Adjustment
Knob
From
Gas
Supply
Figure 45 - Electronic Control Valve
INSTALLING LOG SET
Before proceeding, make sure the gas control valve
is in the “OFF” position. Logs have been shrink
wrapped on a cardboard backing to prevent break-
age during shipping. Cut around perimeter of each
log and pull gently on shrink-wrap to expose log.
Do not pull on log to release it from the shrink-
wrap as this may damage logs.
1. Remove lower louver access panel in re-
place (see step 1 of Wall Switch Installation,
page 21).
2. Remove screen rod by sliding it either to the
left or right of the replace until one of the
rod ends is free and completely remove the
screen from the replace.
3. To open the glass door, undo latches located
on the top and bottom of the rebox (see
Figure 46, page 25). Note: Use caution when
opening these latches. Carefully open the door
by swinging it to the left. The glass door is
mounted to the rebox with 5 screws.
T he e le ct r on ic s ys t em a pp li es t o
t he ( V )D V F3 6 T PN E A/ T ST E A a n d
(V)DVF36TPNPEA/TSTPEA models (see
Figure 45).
 previous next