Filter
Top Products
www.desatech.com
56131-F 23
O
F
F
P
I
L
O
T
O
N
L
O
H
I
P
I
L
O
T
E A
16AI
7
TPTH TP TH
Gas
Valve
To Thermopoile
Extension
Cord
Outlet Box
White
Red
Figure 40 - Installing Remote Receiver
(SKYTECH Model)
Optional Fan
Kit Plug
Receiver
Pull to Remove
Insulation Tab
Battery
Cover
12 Volt
Battery
Figure 41 - Installing Battery in Hand-
Held Remote Control Unit (SKYTECH)
-
An equipment shutoff valve has been included in
the appliance’s gas supply system. You may con-
sider installing an extra gas shutoff valve outside
the appliance’s enclosure (check with local codes)
where it can be accessed more conveniently with a
key through a wall as shown in Figure 42.
Route a 1/2" NPT black iron gas line towards the
appliance coming in from the left. It is recom-
mended to route the pipe between the stand of
the rebox and the surround of the replace (see
Figure 43).
INSTALLATION
Continued
IMPORTANT: The appliance and its individual
shutoff valve must be disconnected from the gas
supply piping system during any pressure testing
of that system at test pressures in excess of 1/2
psig. (3.5 kPa). The appliance must be isolated
from the gas supply piping system by closing its
individual equipment shutoff valve during any
pressure testing of the gas supply piping system
at test pressures equal to or less than 1/2 psig.
(3.5 kPa).
-
1. Install a sediment trap between the incoming
gas line and the gas control valve (see Figure
43). The sediment trap should extend down the
center of the pipe. Refer to your local codes.
3" Min.
Side W
all
Of
Appliance
Incoming 1/2" Gas
Line Permitted by
Local Codes
Figure 43 - Sediment Trap
Sediment
Trap (Not
Supplied)
Figure 42 - Typical Exterior Wall Gas
Shutoff Installation
Key
Extension
Shutoff Valve