www.desatech.com
119315-01A 5
PRODUCT
IDENTIFICATION
Piezo
Ignitor
Screen
Access
Door
Log
Control
Knob
Figure 1 - Vent-Free Mini Compact
Fireplace
PRODUCT FEATURES
This replace has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free room
replaces. The ODS/pilot shuts off the replace if
there is not enough fresh air.
ELECTRONIC IGNITOR
This heater has an electronic ignitor to light heater
fuel supply.
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are four optional remote controls that
can be purchased separately for Remote-Ready
Models only:
• wall switch
• hand-held ON/OFF remote
• wall thermostat
• hand-held thermostat remote
See Accessories, page 34.
ASSEMBLY
WARNING: Always have
-
-
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
• scissors
1. Remove two screws that hold replace screen
in place for shipping. These screws are lo-
cated near top of screen. Discard screws. Lift
replace screen up and pull out to remove
(see Figure 2, page 6). Set screen aside until
installation has been completed.
2. Remove all packaging from inside of unit.
3. Remove bubble wrap from logs and discard.
4. Check installation of brick liners. Brick lin-
ers are in four pieces: 2 sides, 1 back and 1
top.
Brick
Liners
Electronic
Ignitor
Screen
Access Door
Log
Control
Knob
Brick
Liners
Remote
Control