Filter
Top Products
www.desatech.com
119315-01A16
INSTALLATION
Continued
CONNECTIONS
1. Open equipment shutoff valve (see Figure 16,
page 15).
2. Open main gas valve located on or near gas
meter for natural gas or open propane/LP
supply tank valve.
3. Make sure control knob of replace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas regulator (Manual-Controlled Models)
or to gas control valve (Remote-Ready Mod-
els) (see Figures 17 or 18, page 15). Apply
noncorrosive leak detection uid to all joints.
Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light replace (see Operating Fireplace, page
18). Check all other internal joints for leaks.
7. Turn off replace (see To Turn Off Gas to Appli-
ance, page 20 for Manual-Controlled Models
or page 21 for Remote-Ready Models).
REMOTE CONTROL ACCESSORIES
Remote-Ready Models Only
1. Disconnect jumper wire from control valve
(see Figure 19).
2. Locate battery clip mounted on back of re-
ceiver (see Figure 20).
3. Slide 9-volt battery (not included) through
clip.
4. Attach terminal wires to battery (see Figure 20).
5. Connect wires from remote receiver to control
valve as shown in Figure 21.
6. Install remote receiver unit onto remote bracket
using screws provided (see Figure 21).
Figure 21 - Installing Remote Receiver
Remote
Receiver
Figure 19 - Disconnecting Wires From
Control Valve
Figure 20 - Attaching Battery to Receiver
Battery Clip
9-Volt
Battery
Receiver
Terminal
Wires
Control
Valve
Jumper
Wire
White Wire
to TPTH
Terminal on
Control Valve
Red Wire to TH
Terminal on Control
Valve
Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to the battery (not
included). Place battery into the battery
housing.
3. Replace battery cover onto remote control
unit.
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit