Filter
Top Products
Adding a New Transmitter into the System
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
3. Within 5 seconds:
Continue holding the Override switch
and Press Transmitter Button 1*
For remote arming
with
chirp confirmation.
--- or ---
Release the Override switch
and Press Transmitter Button 1*
For remote arming
without
chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All
Other Remote Transmitters From the System)
1. Turn on the ignition.
2. Press and hold the Override switch.
• The status LED will turn on red.
Continue to hold the override switch.
• After 5 seconds, the status LED will flash 4 times, then turn on red again.
3. Within 5 seconds:
Continue holding the Override switch
and Press Transmitter Button 1*
For remote arming
with
chirp confirmation.
--- or ---
Release the Override switch
and Press Transmitter Button 1*
For remote arming
without
chirp confirmation.
• The status LED will flash once quickly to confirm that the new Remote Transmitter
has been added.
4. Turn off the ignition.
* The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program
any
of the
Transmitter’s buttons to arm and disarm the system at this point.
Page 16 - MS8200 / MS8300 Installation Manual
installation_rev3.qxd 7/26/99 6:07 PM Page 16