Filter
Top Products
Page 14 - MS8200 / MS8300 Installation Manual
Using the Remote Transmitters
Each system comes with 2 Remote Transmitters, pre-programmed to Arm and Disarm the
system
with
chirp confirmation using Button 1
.
The Mode Button will change function of both Button 1 and Button 2 each time it is pressed.
When the Arm/Disarm Button is pressed together with any other Transmitter Button, the systems
Chirp confirmation setting will be reversed.
If the system was programmed to arm the system
with
chirp, Pressing Buttons 1 and 2 together will arm the
system
without
chirp.
If the system was programmed to arm the system
without
chirp, pressing Buttons 1 and 2 together will arm the
system
with
chirp.
Note also that the LED on the transmitter changes color each time the Mode Button is pressed
to indicate the current function of Buttons 1 and 2. The LED will stay on for 5 seconds, then turn
off, returning Buttons 1 and 2 to their off settings.
The default setting of the Remote Transmitter is as pictured, where Button 1 is used to arm and
disarm the system , Button 2 operates Auxiliary Function 1, Mode + 1 operates Auxiliary Function
2, etc.
However, it is possible to set individual Remote Transmitters to arm and disarm the system
using any of the Transmitters function Buttons, which is extremely useful when a Transmitter is
used to control multiple system. See
Adding a Remote Transmitter into the System.
The Button Assignment of Arming and Disarming will not affect the operation of the Remote
ARM
Aux 1
Aux 2
greennone
Aux 3
Aux 4
orange red
BUTTON 1
BUTTON 2
MODE BUTTON
LED color
Mode Button Sequence
None:Green:Orange:Red:Green:...
not used
not used
not used
Button 1
Button 2
Mode Button
LED
Remote Transmitters
installation_rev3.qxd 7/26/99 6:07 PM Page 14