Filter
Top Products
19
Setting the bobbin
1. Slide open the bobbin cover.
1 Bobbin cover
2 Bobbin cover release button
3. Guide the thread end through the slit, then pull the thread to-
ward you to cut off any excess thread.
1 Built-in thread cutter
1
2
2. Insert the bobbin into the shuttle with the thread direction as
noted in the diagram.
CAUTION
Always make sure the bobbin is inserted so the thread
feeds out of the bobbin in the correct direction. Setting the
bobbin in backwards could result in poor bobbin tension,
broken needles and possibly injury.
4. Close the bobbin cover by placing the left end in place and
pressing down lightly on the right end so that it snaps into
place.
* Sewing can begin without pulling out the bobbin thread.