Filter
Top Products
68
EMBROIDERING USING A EXTRA-SMALL FRAME
(OPTIONAL)
An extra-small frame which is smaller than the
small frame mentioned on the previous page is
also available as an option. It is used mostly for
monogramming initials on pockets or cuffs.
The extra-small frame can be used to embroider
even smaller articles.
1 Embroidery sheet (vertical type)
2 Embroidery range
3 Maximum embroidering area
– Height : 50 mm (1-15/16”)
4 Maximum embroidering area
– Width : 30 mm (1-3/16”)
5 Center of pattern
CAUTION
Take note of the following when using the
extra-small frame.
1. Always make sure that the initial setting
operation for the carriage (embroidery arm)
after the power is turned on — in other words,
the movement of the carriage (embroidery
arm) in order to set the position — is
completed before installing the extra-small
embroidery frame.
2. Using the arrow keys in the “LAYOUT”
screen, use the “TRIAL” function to check that
the pattern does not extend past the edges of
the frame before starting embroidering.
3. Before touching “TRIAL”, raise the needle and
the presser foot lever to their highest
positions.
* The extra-small frame can also be used
horizontally by changing the position of
attachment to the frame fixing plate. Use a
screwdriver to remove the two screws in order
to change the attachment position.
* Use the horizontal attachment sheet when the
frame is attached horizontally.
1 Frame fixing plate
2 Screws (x 2)
3 Washers (x 2)
4 Nuts (x 2)
5 Embroidery sheet (horizontal type)
6 Embroidery range
7 Maximum embroidering area
– Height : 30 mm (1-15/16”)
8 Maximum embroidering area
– Width : 50 mm (1-3/16”)
9 Center of pattern
CONTENTS
MACHINE
KNOWLEDGE
EMBROIDERING MAINTENANCE
ERROR
MESSAGE
TROUBLESHOOTING
PATTERNS
EMBROIDERING
USING A SMALL
FRAME
(OPTIONAL)
EMBROIDERING
USING A
EXTRA-SMALL
FRAME (OPTIONAL)
EMBROIDERING
USING A LARGE
FRAME
(OPTIONAL)