Filter
Top Products
24
CONTENTS
MACHINE
KNOWLEDGE
EMBROIDERING MAINTENANCE
ERROR
MESSAGE
TROUBLESHOOTING
PATTERNS
EMBROIDERING
USING A SMALL
FRAME
(OPTIONAL)
EMBROIDERING
USING A
EXTRA-SMALL
FRAME (OPTIONAL)
EMBROIDERING
USING A LARGE
FRAME
(OPTIONAL)
ADJUSTING THE LCD SCREEN CONTRAST
To adjust the brightness of the LCD screen
1. Press “BASIC OPERATION”.
2. Touch “NEXT”, “BRIGHTNESS
OF LCD” and “NEXT”.
To adjust the contrast of the LCD screen
1 “Dull” Touch this key to make contrast less
(lighter).
2 “Sharp” Touch this key to make contrast
greater (darker).
3 Touch “END” to return to the screen which
was previously being displayed.
* If the contrast is adjusted too far, the display
screen becomes invisible. Reset it by turning
the power switch off and then on again.
1. While touching the LCD (anywhere is OK),
turn the power off and then back on again.
2. Touch any one of the lower two selection keys
(BASIC OPERATION, MODIFY & ADVISE).
The LCD will become darker each time one of
these keys is touched. If you would like to
make the LCD lighter, touch the upper
selection key (CHARACTERS & DESIGNS).
3. After you have finished adjusting, turn the
power off and back on again once more.
2 1
1 “BASIC OPERATION” key
1
1
2 3
If the LCD is hard to see when the power is turned on